![]() ![]() ![]() Do that via Advanced (Ctrl Alt D) – Rendering Tyles – Water (or keyboard shortcut Ctrl Shift Alt 7). In an environment that makes sense, such as a meeting room, disabling Linden Water can boost frame rates. In some situations the rendering of Linden Water, the water surface and its effects, can significantly reduce frame rates. Peter Kappler also suggested: Particles… a fireplace is going to eat 20 to 30 fps! So turn them off for VR. My suggestion is to look at the frame rate (in Firestorm it is displayed in the upper right hand corner of the viewer) and to adjust the graphics settings (especially draw distance, shadows and quality sliders) until you have around 100fps (and definitely more than 50fps) and then try VR. At low frame rates bad flickering will occur in VR mode. In VR mode you can assume you will get roughly 50% of the frame rate that shows on the 2D normal screen. The Firestorm VR Mod Viewer will not work well if the Second Life/OpenSim region you visit cannot normally be displayed in 2D with a decent frame rate. You do need to ensure you have a good frame rate to have a comfortable VR experience. Other types of Anti-aliasing can be disabled. Create a program-specific profile for the viewer in your graphic card settings and enable FXAA.In case you encounter issues with a black HMD display… Peter suggests the following: In the camera floater two buttons has been added to offset the HMD’s base rotation.Moving the mouse to the corners or the sides will shift the screen to this direction so menus can be accessed.This may be subject to change in future versions. It is better to disable the HMD’s direction interface when editing and flying with the camera. Press F4 to disable and enable HMD’s direction changes.“ C:\Users\your_user_name\AppData\Roaming\Firestorm_圆4\vrconfig.ini”Īnd can be edited directly. By pressing F5 on the last menu entry the menu will close and save the settings in a config file which is located in.Press F5 again to switch to the next menu entry.Press F6 to increase the selected value.The settings menu works only when VR mode is enabled. Press F5 to open the settings menu, you should see a text menu in the middle of the screen.Press TAB key to enable and disable VR mode.Do this each time you want to enter VR mode after starting up. Press CTRL TAB to load or unload the SteamVR driver.Instructions are available via prompts in the viewer or via information on. Protective code to avoid the activation of extended BoM features for older OpenSim grids is planned to be included in a future Firestorm release. Universal wearables) please don’t use this viewer to log directly into an OpenSim grid/region known to run on older 0.8.* server code (not updated for over 4 years!). Most of the time this will work fine, but if you use extended BoM features (e.g. The version of the Firestorm viewer on which the latest Firestorm VR Mod 6.9 is based supports Bakes on Mesh in both Second Life and OpenSim. Usage information below.įor community support use the Discord Discussion Channel: P373R-WORKSHOP by p373r_kappler You can then start the viewer and follow the on screen instructions. Then copy the provided openvr_api.dll file into the Firestorm VR Mod directory, at the same level as the. It is, by default, installed in its own directory and can sit alongside the standard Firestorm release. Unzip the release file, install the version of Firestorm VR Mod provided. On 2 Peter Kappler provided an update to his Firestorm VR Mod Viewer at – go there to download the latest version and for usage information, source, advice on trouble shooting, etc. A later version of Firestorm VR Mod 6.3.9 is available. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |